1/15/2024 0 Comments 2012 chevy cruze oil in coolantClamp it carefully with channel locks (this was to provide additional heat shielding to the end under exhaust Manifold)ġ1) Stand back, take pictures, have a beer, and think about the savings- (the price of a 1/4 inch hose clamp)ĩ) Clean up the old swage fitting of sharp edges and reinstalled it over the end that was just repaired right up to the hose clamp. Fit it neatly back in place with cut facing toward the engine blockĩ) Clean up the old swage fitting of sharp edges and reinstalled it over the end that was just repaired right up to the hose clamp. is an recall in the 2011 Chevy Cruze but Chevy doesn't have the 2012 as a. You may see brown sludge sitting in the coolant reservoir when this occurs. Yet, when it fails, oil is going to leak into the cooling system or vice versa. It keeps the oil from mixing with the coolant. GM Class Action Lawsuit Dismissed Over Oil. Blown Head Gasket The head gasket is located between the engine block and cylinder head. I did a quick fix on this known problem leaker as follows: didn't even have to drain the coolantĢ) Confirm leaking coolant ( had a burning smell off and on until, when changing the oil this weekend found and traced a puddle of coolant to this hose, where the rubber hose is swagged to the metal line.ģ) Removed lifting eye on engine head to work on hoseĤ) Carefully cut the metal swage off (careful not to damage the hose underneath) with a dremel and metal cutting wheelĦ) Removed hose quickly and slide the aluminum heatshield tubing off to reuseħ) Quickly put hose back on the steel line with hose clamp and tightened the clamp.Ĩ) Cut the heat shield tubing on the inside longitude leaving space for the added clamp to insuring it goes as close as possible to metal line). If you have oil in your coolant and have one if the following cars you need to replace your oil cooler or the seals inside the oil cooler.Chevrolet SonicChev. The 2012 Chevrolet Cruze has 18 problems reported for coolant leak. 1) Install the oil pressure indicator switch to the oil cooler. 24) Remove the oil pressure indicator switch from the oil cooler. Replaced Water Inlet hose from Water Outlet to Coolant Expansion Tank (GM OEM part 13251447) - 34.98. Replaced Water Outlet (Doorman part 902-846) - 33.99. If they aren’t leaking then check the coolant reservoir hose to see if the plastic tube isn’t cracked inside it. 23) Remove the oil cooler (1) in compound with the oil cooler gasket (2) and the seal ring (3). Just as a quick update to anyone who stumbles across this post, I've completed the following: Replaced Coolant Expansion Tank (Dorman part 603-383) - 29.99. Fill the coolant surge tank with the proper DEX-COOL coolant mixture to the indicated level mark. 213 2011 Ford automatic transmission no-starts, hard starts. The turbo coolant line must be replaced when you do the turbo. Check for a leak on the water outlet assembly and also check both sides of the oil cooler bypass tube, especially the side under the exhaust manifold. Keep turning the pressure cap slowly and remove it. Oil, coolant and fuel capacity for Chevrolet Cruze LT in 2012, the model offered since mid-year 2011 in North America - factory declared capacities of oil, coolant and fuel.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |